Sikadecor 803 Bi-component grey microcement 30 kg

Mortar plaster for levelling surfaces prior to the application of decorative micro-cements. Pre-measured batches of 30 kg, grey in colour. SikaDecor-803 Nature is a two component coating formulated with Portland cement. Formulated from Portland cement, selected aggregates, additives and synthetic resins selected aggregates, additives and synthetic resins for high performance high performance for levelling surfaces prior to the application of decorative microcement.

USES :

SikaDecor -803 Nature is suitable for :

• Régularisation des surfaces avant l’application de microciments décoratifs.
• decorative microcement.
• Filling of tile joints in tiled or screeded substrates before the application of microcement.
• tiled or screeded substrates, before the application of decorative microcement.
• decorative microcement.
  SikaDecor®-803 Nature can be used as a regulator on a wide variety of substrates such as :
• Concrete and mortar.
• Brick
• Floor and wall coverings with old tiles (for these surfaces the use of a primer is recommended)
  (for these substrates, the use of a primer is necessary).
• In general, all types of porous substrates.
• SikaDecor®-803 Nature can be used on interior and exterior walls and floors.

BENEFITS :

• Pre-measured Product
• Easy to apply on site
• Low shrinkage

PACKAGING :

• Pre-measured batch of 30 kg

COLOUR :

• Component A: Grey powder / white powder
• Component B: whitish liquid

Chemical basis :
Two-component polymer mortar

Storage :
12 months from the date of manufacture in its original, unopened and undamaged packaging,

Storage conditions :
In dry conditions, at

Temperatures :
between + 5°C and + 25°C. Protect from frost.

Density :
~ 2kg/l (a +20ºC)

Consumption :
~ 2.0 kg/m2/mm which corresponds to an approximate yield of 15 m2. Consumption may vary depending on substrate conditions (porosity, surface roughness, permeability, etc.).

Ambient temperature :
Min. +8 °C, max. +30 °C

Supporting temperature :
Min. +8 °C, max. +30 °C

Waiting time / Possibility of repainting :
About 24 hours.
Curing times are approximate and may be affected by changes in weather and substrate conditions. changes in weather and substrate conditions.